Using The Device For The First Time; Scope Of Supply; Device Function - Riester RBP-100 Manual Del Usuario

different from that supplied may result in measurement error.
The Riester RBP-­100 is not intended for patients connected to a
cardiopulmonary bypass machine.
If Luer Lock connectors are used in the constructions of tubing, there is a possibility
that they might be inadvertently connected to intravascular
fluid systems, allowing air to be pumped into a blood vessel.
The Riester RBP-­100 must be charged before using it for the first time.
For accurate blood pressure measurements, ensure that the
circumference of the arm fits within the range markings on the cuff.
Only use such accessories as are recommended for use with this device.
Compressing the pneumatic tubing may cause system errors.
Prevent water or other fluids from entering any connectors or vents on
the device. Should this happen, all connectors should be dried with warm air. Then
check the calibration of the device and operating functions before reusing.
If the Riester RBP-­100 is dropped or mishandled, please have it checked by a
authorized service center before bringing it back into use.
At least every three months, inspect cords and accessories for fraying or other
mechanical damage. Replace as necessary.
Check the calibration of your Riester RBP-­100 at least once every two
years.

2. USING THE DEVICE FOR THE FIRST TIME

2.1 SCOPE OF SUPPLY

2. Using the device for the first time
2.1 Scope of supply
1 pc soft cuff size M (22 -­ 32 cm / 8.7 -­ 12.6 inches)
1 pc soft cuff size M (22 - 32 cm / 8.7 - 12.6 inches)
1 pc soft cuff size L-­XL (32 – 52 cm / 12.6 -­ 20.5 inches)
1 pc soft cuff size L-XL (32 – 52 cm / 12.6 - 20.5 inches)
1 pc 2.5m air tube with metal connector
1 pc 2.5 m air tube with metal connector
1 pc AC/DC Adapter 7.5 V / 1500 mA
1 pc NIMH AA 4.8 V 2400 mAh rechargeable battery-pack
1 pc instruction booklet
2.2 Device function

2.2 DEVICE FUNCTION

RBP-­100
RBP-­100 USB
RBP-100
Seite 6 von 24