MANUAL MCM-1631.pdf
3.Rotate the knob to steam position, to start the steam
system cleaning for 1 minutes. When the cycle is
finished, the machine will return to stand-by mode.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical support
service if problems arise. Do not try to dismantle or
repair without assistance, as this may be dangerous.
- If the connection to the mains has been damaged, it
must be replaced and you should proceed as you would
in the case of damage.
- If you detect any anomalies, refer to the following
table:
Anomaly
Water flows out of the side
of the holder
No coffee comes out
C
M
Y
CM
MY
CY
The coffee comes out slowly
or drop by drop
CMY
The coffee comes without
K
cream
The coffee comes out too fast
No steam escapes from
the evaporator tube
FOR EU PRODUCT VERSIONS AND/OR IN CASE
THAT IT IS REQUESTED IN YOUR COUNTRY:
ECOLOGY
AND
PRODUCT
- The materials of which the packaging of this applian-
ce consists are included in a collection, classification
8
26/10/18
8:05
Possible cause
• The filterholder is not fitted
correctly.
• The Edge of the sieve
is covered with coffee.
• The brewing group is dirty.
• There is no water
• The water tank is not properly
placed.
• The filter holes are clogged,
the coffee is ground too fine or
has been pressed too much
The coffee grinding is too fine
or too pressed
• The used Coffee is out of date
• The Coffee has not been
pressed enough.
• The Ground coffee is too coarse.
• The ground coffee is too coarse.
• There is not enough coffee
in the sieve.
• The Coffee has not been
pressed enough
The Tube is clogged
RECYCLABILITY
OF
THE
and recycling system. Should you wish to dispose of
them, use the appropriate public recycling bins for each
type of material.
The product does not contain concentrations of
substances that could be considered harmful to the
environment
- This symbol means that in case you
wish to dispose of the product once its
working life has ended, take it to an
authorised waste agent for the selective
collection of waste electrical and electronic equipment
(WEEE)
Solutions
• See Section "filling coffee"
• Clean the sieve around the
edge and clean the brewing
of coffee group
• Clean With a damp cloth.
• Fill the water tank
• Make sure the tank is properly
seated, pressing the tank forward
and ensure the tank is locked by
the water tank buckle
• Empty the filter basket and
clean with water. Clean the
brewing unit with a damp cloth.
Fill the sieve again and press
the coffee slightly
Make sure grinding is OK
and it's not too pressed.
• Use Fresh coffee and once
opened store in an airtight
container.
• Press slightly the coffee.
• Grind finer the coffee
• Grind coffee finer
• Ensure that it's the right
amount of coffee in the sieve.
• Press slightly the coffee
Clean the steam tube with a damp
cloth to remove any traces of milk
have dried and unblock holes using
a needle. Press the corresponding
switch and remove steam until it
goes out continuously