Mellerware Prosteam 3000 Manual Del Usuario página 6

If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the ap-
pliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
FILLING WITH WATER:
- It is essential to have filled the deposit with
water to be able to work with steam.
- Open water inlet lid.
- Fill the deposit taking care to observe the MAX
level (Fig.1).
- Close water inlet lid.
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Turn the thermostat control to the desired tem-
perature position.
- Do not use temperatures higher than those
indicated on the garments to be treated.
● Temperature for synthetic fibres (Polyester,
Nylon...).
●● Temperature for silk and wool.
●●● Temperature for cotton. (Minimum tem-
perature for steam ironing)
Max Temperature for linen.
- If garment has various kinds of fibres, select
the temperature for the fibre that requires the
lowest temperature. (For example, select the
temperature for polyester for an article made
out of 60% polyester and 40% cotton).
- Wait until the pilot light (F) has gone out which
will indicate that the appliance has reached an
adequate temperature.
- During the appliance's use the pilot light (F) will
come on and off automatically, indicating the
heating elements are working, and therefore
maintaining the desired temperature.
DRY IRONING:
- The appliance has a steam flow regulator
that permits dry ironing (without steam) when
placed in the 1 position.
STEAM IRONING:
- It is possible to iron with steam whenever the
deposit is filled with water and the adequate
temperature is selected.
STEAM FLOW CONTROL:
- The appliance has a control knob (C) that
allows getting the control of the steam flow.
SPRAY:
- The spray can be used in both steam and dry
ironing.
- Press the spray button (A) to use this opera-
tion.
- The spray button has to be pressed repeatedly
to release the first spray.
STEAM BLAST:
- This function proportions extra steam for elimi-
nating wrinkles.
- Press the steam blast button (B). Wait a few
seconds until vapour penetrates the fibres of
the garment before pushing the button again.
For optimum steam quality, do not apply more
than three successive blasts.
- The steam blast button has to be pressed
repeatedly to release the first shot.
VERTICAL STEAMING:
- It is possible to iron hanging curtains, items of
clothing on his hanger, etc. To do so, follow the
instructions:
- Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction (Fig.2).
- Move the iron in a top to bottom direction while
pressing the steam control (B). Important: for
cotton and linen, it's recommended to put the
iron base in contact with the material. For other
more delicate fibres, it's recommended to keep
the iron base at some centimetres of distance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance from the mains.
- Remove the water from the inside of the appli-
ance.
- Clean the appliance.