Matrix R30 Manual Del Usuario página 46

A Open HARDWARE FOR STEP 1.
1
B Carefully pull the CABLES (1) through the CONSOLE MAST (2)
using the LEAD WIRE (3) located inside the CONSOLE MAST
(2). Discard the lead wire.
C Attach the CONSOLE MAST (2) to MAIN FRAME (4) using 4
R30
BOLTS (A) and 4 SPRING WASHERS (B). Torque settings: 23.1
R50 Nm / 17 lb-ft.
Note: Be careful not to pinch any wires while
attaching the console mast.
Hardware For Step 1
Description Qty
3
B
A Bolt 4
B Spring Washer 4
1
2
4
90
MXR20_AG_Bikes_r1_0_B.indd 90-91 MXR20_AG_Bikes_r1_0_B.indd 90-91
A Open HARDWARE FOR STEP 2.
2
B Slide TOP CAP REAR COVER (5) over CONSOLE MAST (2) and snap into place.
C Slide TOP CAP FRONT COVER (6) over CONSOLE MAST (2) and snap into place
D Attach HANDLEBARS (7) to CONSOLE MAST (2) using 2 BOLTS (C) and 2 SPRING
R30
WASHERS (B). Torque settings: 23.1 Nm / 17 lb-ft.
R50
Hardware For Step 2
Description R30 R50
C Bolt 2 6
B Spring Washer 2 6
L Flat Washer 0 4
R50
Y Use outside holes for XUR console
A
Z Use inside holes for all other consoles
Y Z Y
7
7
C
2
B L
5
A Open HARDWARE FOR STEP 3
3
B Attach the WATER BOTTLE HOLDER (8) to the SEAT FRAME
ASSEMBLY (9) using 2 SCREWS (D).
C Attach the SEAT FRAME ASSEMBLY (9) to the SEAT SLIDE
(10) using 4 BOLTS (E) and 4 SPRING WASHERS (F). Torque
R30
settings: 23.1 Nm / 17 lb-ft.
R50
D Connect the CABLES (11).
Note: Be careful not to pinch any wires while attaching the seat frame.
Hardware For Step 3
Description Qty
D Screw 2
E Bolt 4
F Spring Washer 4
E
8 F
B
D 9
C 6
11
10
A Open HARDWARE FOR STEP 4
4
B Attach the SEAT BOTTOM (12) to the SEAT FRAME ASSEMBLY
(9) using 4 BOLTS (G) and 4 SPRING WASHERS (H). Torque
settings: 9.5 Nm / 7 lb-ft.
R30
R50
Hardware For Step 4
Description Qty
G Bolt 4
H Spring Washer 4
12
9
H
G
R50 SHOWN 91
10/16/20 2:16 PM 10/16/20 2:16 PM