Worx LANDROID Guia De Instalacion página 17

LED light indicator
Light does not turn on
Green light on
Green light on, Landroid is
®
inside its territory but does not
move.
Green light flashing
Red light on
4. Turn on and Test the Installation
This is the exciting part where you can turn your Landroid
Status
There is no power.
Boundary wire is connected
successfully; fully charged.
Boundary wire is connected in
wrong direction.
Power supply is connected
successfully, while the wire is
connected unsuccessfully.
Charging
Action
Check if the power cord is connected properly to the
charger and the charger is connected to a suitable power
supply.
/
Check and reverse two ends of boundary wire.
Check that the Boundary Wire has been connected
correctly to the charging base.
Check there are no breaks in the boundary wire.
/
on for the first time.
®
4.1
Adjust the cutting height to its maximum level (60mm) for the
first mow and then adjust to your preferred lawn grass height.
Place your Landroid inside the working area, a few meters
®
from the back of the charging base. Landroid
on, will go through the entire boundary wire before returning
to charging base. This allows you to check if the boundary wire
is laid out properly.
Set the main switch at the rear of Landroid
Press " " button and then press "OK" button.
4.2
Your Landroid now is finding its way to the charging base.
®
Watch the Landroid as it returns to the charging base and
®
modify the positioning of the boundary wire if necessary.
When the Landroid successfully returns to the charging
®
base, this means the installation has been successfully
completed!
NOTE: If the boundary wire is broken during the testing or
you find you need to extend the boundary wire, please refer
to "Joining the Boundary Wire" in Owner's Manual for
instructions.
, after turning
®
17
EN
to Position "I" .
®