Battery Removal - Remington Ultimate F7 Manual De Instrucciones

ENGLISH
• Do not clean the shaving foil with a brush.
• Replace the head assembly by placing the assembly on top of the hair pocket, press
down and click into place.
CLEANING TRIMMER
• Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
REPLACING THE FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils
and cutters are replaced every six months.
SIGNS THAT YOUR FOILS AND CUTTERS NEED REPLACING.
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL:
1. Remove the foil assembly by pressing the foil assembly release buttons on either side
of the head and lifting the assembly upwards to remove from the hair pocket.
2. Insert the new foil assembly on the hair pocket, press down and click into place.
REPLACING THE CUTTERS
1. Grasp the cutter between your thumb and forefinger and pull upwards.
2. Snap the new cutter into the oscillator tip.Note: DO NOT press on the cutter ends as
this may cause damage.
3. Foil head replacements can be found on the Remington website.
TROUBLESHOOTING
If your shaver battery is completely empty or the shaver has not been used for an
extended period of time, the shaver may not start when operated using the cord. If this
occurs, a 5 minute quick charge will allow for 3 minutes of shaving.

BATTERY REMOVAL

We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Slide the trimmer up to the open position and remove a single philips head screw.
2. Using a small screwdriver, pry off the rear housing.
6