Snow Joe AUTO JOE AJS8000 Manual Del Operador página 8

3. Clamp the positive (red) clamp to the positive terminal on
the vehicle battery, and clamp the negative (black) clamp
to the negative terminal of the car battery, the vehicle
frame (ground) or other negative connection point as
recommended by the vehicle manufacturer (Fig. 4).
1
Connect positive clamp
(red) to positive terminal
Order of Connecting
m
CAUTION!
Make sure the jumper cable is not within
range of moving engine parts (belts, fan, alternator, etc.). Both
the device and the cable must be placed on a nonflammable
surface.
4. After connection, check the jumper cable to make sure
the connection is correct and the battery is in the normal
voltage range. The LED indicator on the jumper cable
should turn on solid green if the jump starter is in normal
status and ready for use.
NOTE: Check the table below for the jumper cable
behavior and the corresponding status. After the
connection is correctly made, you will have about 30
second to start the car. The device will return to standby
mode after 30 seconds.
Jump Start Cable Behavior
Red + green light flashing
LED light turns red + buzz
warning sound
LED light turns solid red
LED light turns solid green
NOTE: If the jumper cable LED indicator doesn't turn on,
make sure the connection is secured.
5. Start the vehicle (turn on the vehicle ignition).
Fig. 4
2
Connect negative clamp
(black) to negative terminal
+
-
Corresponding Status
The jump starter is
connected and the inner
batteries are in the normal
voltage range.
Reverse battery terminal
connection or short-circuit.
The jump starter doesn't
have enough power.
The connection is
successful and the jump
starter is ready for starting
the car.
NOTE: If the vehicle doesn't start within 6 seconds, let the
jump starter cool for 3 minutes before attempting to start
the vehicle again or you may damage the jump starter.
NOTE: During very cold conditions, the vehicle may not
start on the first attempt. We suggest attempting to start
a second or third time, as the starting attempt will warm
the internal battery and improve your starting chances.
Do not attempt to start after four attempts. Either the unit
does not have sufficient power to start the vehicle or there
is a more extensive problem with the vehicle than simply a
depleted battery.
6. To disconnect the jump starter cable, make sure to:
i. Disconnect the negative (black) clamp from the vehicle.
ii. Disconnect positive (red) clamp from positive battery
terminal.
iii. Disconnect the cable from the jump starter.
Charging Mobile Devices
m
WARNING!
Do not insert a nail, wire, etc. into any
receptacle. Otherwise a circuit short may cause smoke or fire.
1. Plug a USB cable into either one of the two USB ports.
You can charge up to 2 devices at a time.
2. Connect the USB cable to the mobile device(s) and press
the power button to start charging (Fig. 5).
Fig. 5
3. The jump starter can also power a 12V DC device such
as DC fans. Connect the device to the DC barrel jack of
the jump starter with a suitable DC cable (not included),
and press the power button to start charging (Fig. 6).
Fig. 6
Power button
8
Power button
DC receptacle