Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The jump starter can be charged by:
• AC adapter with the equipped USB charging cable;
• Vehicle's cigarette lighter socket/12 V DC outlet with the
equipped car charging cable;
Follow the instruction below to charge the jump starter.
USB CHARGING
Fig. 1
Charging level
indicator
1. Check that the mains voltage is the same as that marked
on the rating plate of the AC adapter (not included). Then,
plug a USB charger into an AC power outlet.
2. Turn off the jump starter and remove all loads connected
with the jump starter. Using the provided USB charging
cable, connect the jump starter with the USB charger
(Fig. 1).
3. It will take approximately 6 hours to charge the jump
starter. The battery level indicator LEDs will cycle on one
by one during the charging process. Unplug the charger
when all 4 LEDs are all illuminated.
NOTE: The jump starter is equipped with overcharge
protection, the charging process will stop when the jump
starter is fully charged and the 4 LEDs are all illuminated.
For better performance of the internal batteries, do not
leave the appliance connected with the charging cable for
long after it's fully charged.
CAR CHARGING
Fig. 2
1. Turn off the jump starter and remove all loads connected
with the jump starter.
Jump Start a Vehicle
Charge socket
When jump starting a vehicle with this device, make sure that
it is at least 50-75% charged (3 indicator LEDs are lit when the
USB charging cable
power button is pressed). To achieve optimum performance,
do not store this device at temperatures below 50°F (10°C)
before using as a starting aid. Never charge or start a vehicle
with a frozen battery.
m
this unit. NEVER use other cables and alternative solutions.
Follow the instructions below to jump start an vehicle.
Charging level
indicator
Car charging cable
Charge socket
7
2. While the car is running, use the equipped car charging
cable to connect the jump starter charge socket and the
car's 12V DC outlet (Fig. 2).
3. It will take approximately 4 hours to charge the jump
starter. The charge level indicator LEDs will cycle on
one by one during the charging process. Unplug the car
charging cable when all 4 LEDs are all illuminated.
NOTE: The jump starter is equipped with overcharge
protection, the charging process will stop when the jump
starter is fully charged and the 4 LEDs are all illuminated.
For better performance of the internal batteries, do not
leave the appliance connected with the charging cable for
long after it's fully charged.
CAUTION!
Always use the equipped jumper cable with
• Read the operating manual/safety manual provided by the
vehicle manufacturer before jump starting the vehicle.
• Jump start a vehicle only in a well-ventilated area.
• Always wear safety glasses when working with batteries.
1. Insert the jumper cable into the jumper cable jack. Be
sure that the jumper cable connection is secure. Upon
connection, the LED indicator on the cable will flash in red
and green, indicating that the unit is in standby mode
(Fig. 3).
Jumper cable
Jumper cable LED
indicator
Jumper cable
jacks
2. Switch off the ignition completely before connecting the
device to the vehicle.
Fig. 3
Tabla de contenido
