Vimar 41002 Manual De Instrucciones página 28

41002 - 41005
will group the buttons for the calls.
By default the speech units come with the buttons grouped in
twos horizontally to use the single axial button Art. 41110. This
button can actuate one or both mechanical buttons on the same
row.
There is also the single rocker button, Art. 41111, that lets you
actuate the single mechanical button and the double axial but-
ton Art. 41112 which actuates up to 4 buttons.
The (PREVIOUS) and
tween the possible values. If you try to go before the first or after
the last one, the speech unit will emit a tone to warn you that
there are no other valid values.
If you start from a configuration with the LEDs flashing, first
pressing the button (PREVIOUS) will set the first possible
value, while pressing the
possible one.
Article Description
41111 Single rocker button
Single axial button
41110
(default)
41112 Double axial button
Pressing (DEL) takes you back to the previous level, with-
out saving any changes.
Press (OK) to confirm what you have chosen.
Note: For the 10 button module Art. 41010, by selecting the
Double axial button mode, the last pair of buttons is forced to
Single axial button.
With SaveProg you can change the grouping in a totally arbi-
trary manner, except that the last row of each module cannot be
configured as a Double axial button.
The following figure outlines the configurations of the speech
unit and a button module in the three possible cases and their
respective indoor units corresponding to each group. For calls,
reference is made to the first external module.
28
(NEXT) buttons change be-
button (NEXT) will set the last
LED
Single rocker
button
1 2
3 4
5 6
7 8
10
9
11 12
14
13
The chosen positioning for the indoor units, with gaps in the
numbering, means you don't have to re-code the existing indoor
units or have to re-configure the existing speech units, if the
button grouping is later changed either with this procedure or
with SaveProg.
10. Enabling the camera (41002 only)
With this procedure you can enable (default ) or disable the
camera connected to module 41002.
Note: If display 41018 is connected to the module 41002, con-
figuration using the 4 pushbuttons is not enabled. In this case,
use SaveProg, or momentarily disconnect the display, wait 30
seconds for the entrance panel to recognise that the display is
no longer connected, then proceed with the configuration proce-
dure after which you can re-connect the display.
LED configuration
The (PREVIOUS) and
tween the possible values. If you try to go before the first or after
the last one, the speech unit will emit a tone to warn you that
there are no other valid values.
Pressing (DEL) takes you back to the previous level, with-
out saving any changes.
Press (OK) to confirm what you have chosen.
EN
Single axial
button Double axial
(default) button
1
1
3
5
5
7
9
9
11
13
13
Meaning
Enabling the camera
Camera disabled
Camera enabled (default)
(NEXT) buttons change be-