Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATS-42R
ATS-42T
Order No. 25.4560
Order No. 25.4570
Voice Transmission System
GB
Please read these operating instructions care-
fully prior to operation and keep them for later
reference.
1 Applications
In combination with a receiver or several re-
ceivers ATS-42R, the transmitter ATS-42T pro-
vides a mobile wireless system for transmitting
spoken language, e. g. for guided tours, lectures
in different languages or wireless command
transmission. For wireless transmission, 40 chan-
nels are available in the frequency range
863 – 865 MHz; up to twelve of these channels
may be used at the same time without mutual
interference. The transmission range depends
on local conditions and may reach 50 m as a
maximum.
2 Important Notes
The units correspond to all relevant directives of
the EU and are therefore marked with
G
The units are suitable for indoor use only. Pro-
tect them against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature: 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never
use water or chemicals.
G
No guarantee claims for the units and no lia-
bility for any resulting personal damage or ma-
terial damage will be accepted if the units are
used for other purposes than originally in-
tended, if they are not correctly connected or
operated, or if they are not repaired in an ex-
pert way.
If the units are to be put out of opera-
tion definitively, take them to a local re-
cycling plant for a disposal which is not
harmful to the environment.
2.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the transmitter ATS-42T is in accordance
with the basic requirements and the other rele-
vant regulations of the directive 1999 / 5 / EC. The
declaration of conformity is available on request
from MONACOR INTERNATIONAL. The trans-
mitter is licence-free and generally approved for
operation in EU and EFTA countries.
1
2
3
4
ATS-42T
TX
ATS-42R
RX
ATS-42T PLL TRANSMITTER
3 Setting into Operation
3.1 Inserting / Replacing the batteries
To insert or replace the batteries, remove the
cover of the battery compartment on the rear
side of the unit. Insert two batteries of size AA as
indicated in the compartment, then replace the
cover.
If the unit is not in use for a longer period of
time, remove the batteries to prevent damage to
the unit due to battery leakage.
Used batteries and defective recharge-
able batteries must not be placed in the
household waste. To protect the envi-
ronment, always take them to a special
waste disposal, e. g. collection con-
tainer at your retailer.
3.2 Recharging the batteries
Instead of batteries, rechargeable batteries can
be used for the transmitter and the receiver. To
recharge the batteries, the chargers TXA-12C,
.
TXA-36C and TXA-800PS are available from the
product range of MONACOR. Put the receiver
and the transmitter into the chargers, including
the batteries inserted.
CAUTION! If you use non-rechargeable batter-
ies for the units, never put them in the charger. If
you try to recharge non-rechargeable batteries,
they may leak or even explode.
3.3 Connecting the microphone
and the earphone
1) Connect the microphone provided to the jack
(3) of the transmitter (grey housing) and use
the clip to fasten it to your clothes (e. g. tie,
lapel).
2) Connect the earphone provided to the jack
(3) of the receiver (black housing) and fas-
ten it to your ear.
4 Operation
1) First switch on the receiver only: Keep the but-
ton
(7) pressed until the display (5) shows
"On".
2) Set a free transmission channel on the re-
ceiver with the button
Note: Five seconds after switching on and five
seconds after pressing a button, the buttons
will be locked automatically: The symbol ap-
pears on the display. To unlock, keep both but-
tons pressed until the symbol disappears.
The LED RX (2) must not light up. If it lights
up, interference or signals from other trans-
mitters are received. In this case, use a differ-
ent channel.
5
1 Antenna
6
2 Indicating LED
ATS-42T: transmitter switched on
ATS-42R: a signal is received
7
3 3.5 mm jack
ATS-42T: for the microphone
ATS-42R: for the earphone
4 Volume control
ATS-42T: for the microphone
ATS-42R: for the earphone
5 Display to indicate the lock feature , the
transmission channel (01 – 40) and the battery
status
8
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
©
Copyright
by MONACOR INTERNATIONAL. All rights reserved.
3) Switch on the transmitter; the LED TX (2)
lights up. Set the transmitter to the transmis-
sion channel of the receiver. Once a signal is
received, the LED RX will light up.
4) Use the control
the desired volume for the earphone and the
control
for the microphone so that the microphone
signal is neither distorted (in this case reduce
the volume) nor noisy (in this case increase
the volume).
Caution! Never adjust the earphone to a very
high volume. Permanent high volumes may
damage your hearing!
5) If several ATS-42 systems are used at the
same time for transmitting different kinds of in-
formation or different languages, set a differ-
ent transmission channel for each separate
system. You will be able to make twelve voice
transmissions at the same time if you set the
following channels:
1, 2, 13, 17, 19, 20, 21, 22, 24, 28, 39, 40.
6) To switch off the units, keep the button
of each unit pressed until the display shows
"OF".
5 Specifications
Transmission frequency: 863 – 865 MHz
Transmitting power: . . . ≤ 10 mW (EIRP)
Range: . . . . . . . . . . . . . approx. 50 m
Power supply: . . . . . . . . 2 batteries / recharge-
Ambient temperature: . . 0 – 40 °C
Dimensions: . . . . . . . . . 66 × 102 × 26 mm
Weight: . . . . . . . . . . . . . 60 g
Channel assignment
Channel MHz Channel MHz Channel MHz Channel MHz
01
863.075
02
863.275
03
863.475
04
863.675
05
863.875
or
(6).
▲
▼
06
864.075
07
864.275
08
864.475
09
864.675
10
864.875
Subject to technical modification.
6 Buttons for setting the transmission channel
Five seconds after switching on and five sec-
onds after pressing a button, the buttons will
be locked automatically: The symbol
pears on the display. To unlock, keep both but-
tons pressed until the symbol disappears.
7 On / off switch: keep it pressed for approx.
1 second
8 Contacts to recharge the batteries inserted via
a suitable charger
(e. g. TXA-12C, TXA-36C, TXA-800PS)
(4) on the receiver to set
on the transmitter to set the volume
able NiMH batteries
of size AA
11
863.175
21
863.025
31
863.125
12
863.375
22
863.225
32
863.325
13
863.575
23
863.425
33
863.525
14
863.775
24
863.625
34
863.725
15
863.975
25
863.825
35
863.925
16
864.175
26
864.025
36
864.125
17
864.375
27
864.225
37
864.325
18
864.575
28
864.425
38
864.525
19
864.775
29
864.625
39
864.725
20
864.975
30
864.825
40
864.925
ap-
A-1359.99.01.09.2012
Tabla de contenido
