Tools Required - Eaton LUMARK Crosstour LED Manual Del Usuario

Installation Instructions - Crosstour LED Knuckle Kit
INSTALLATION
Available on 7W, 18W, 26W and 38W models only.
N ote:

Tools Required

Phillips head screw driver and electrical wiring tools.
1. Loosen the knuckle pivot screw. Adjust the position of
the knuckle stem. Re-tighten. (Figure 1.)
2. Route electrical leads through the 1/2" NPS cover
plate (supplied by others). Seal knuckle threads with
sealing compound (provided by others). Secure cover
plate to knuckle with lock nut (50-60 in-lbs). Make wire
connection in outdoor rated junction box. Mount cover
plate to junction box. (Figure 1.)
CAUTION
DO NOT mount the cover plate to junction box prior to
mounting knuckle flood base assembly to cover plate. This
can result in twisted wires causing connections to break,
which can create a shock hazard when powered.
3. Separate Crosstour housing door from the back box.
Remove the indicated gasket punch outs on the back
box. (Figure 2.)
4. Use the supplied four 8-32 x 1/2" Phillips head screws
to attach the back box to the knuckle flood base
assembly. The wire leads must be pulled through
the center wire way hole. Utilize the locating tab on
the knuckle flood base plate to align to the back box.
Tighten/torque all four screws to 30-40 in-lbs. Ensure
all screws are equally tight. Ensure that the knuckle
plate is FULLY compressed against the back box. Full
compression will result in no visible gap between the
back box and knuckle flood base. (Figure 3.)
5. Make wire connections between the knuckle leads and
Crosstour luminaire leads (Figure 4.). Re-attach door to
housing tighten/torque to 15-20 in-lbs. Attach optional
visor and impact guard. (Figure 5.)
6. Adjust aiming angle of the fixture by loosening the pivot
screw. Use visual angle indicators to set desired angle.
Tighten/torque pivot screw 50-60 in-lbs.
Figure 1.
2
EATON
IB506005EN Installation instructions
Center Wireway
Figure 2.
Figure 3.
Crosstour without Photocontrol
Connect all
Ground Wires First
Crosstour with Photocontrol
Load (Red)
Neutral (White)
Line (Black)
Wire Nut Supplied by Others
Figure 4.
Outer Slot
Locating Tab
Supply Line (Black)
LED
Load (Black)
Driver
Neutral (White)
Supply Neutral (White) Factory Wired
LED to Driver
Supply Neutral (White)
Load (Black)
LED
Driver
Neutral (White)
Supply Line
Factory Wired
(Black)
LED to Driver