Health Zenith SL-6153 Manual De Instrucciones página 3

3. The doorbell button and chime both have eight different jumper locations.
The jumper positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers as needed. There are
128 different combinations. It is recommended to only change one jumper
at a time and then check to see if system is functioning properly. Note:
Jumpers in positions 1 through 7 must be exactly the same for both the
doorbell button and chime for this system to function.
®
Your Heath /Zenith wireless doorbell has 3 different selectable tunes: Ding
(one note), Ding-Dong (two note), or Westminster (eight note). The factory
setting is for the Westminster; however, this can be changed by following the
instructions below.
• Ding (one note tune)
Doorbell button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Doorbell button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune)
Doorbell button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: Model 6162 has doorbell buttons for both front and back door. The
back door must use the Ding tune and the front door may use either the
Ding-Dong or Westminster tune.
Inside Chime
595-5611-05
Tune Settings
Doorbell Button Battery Replacement
Install an alkaline type A23 12 Volt battery. The
positive terminal should be positioned as shown.
Tune
Setting
Doorbell
* Code Settings 1-7
Inside
Button
-3-
Must Match Both
Doorbell Button
and Chime