Bypass Mode - GYS CAP Manual De Instrucciones

Operating manual

BYPASS MODE

If starting has failed during standard troubleshooting and charging, the vehicle's on-board computer may not allow start-
ing because the battery voltage.
GYSCAP
Check the connections before proceeding to the next step.
DO NOT REVERSE POLARITIES (protection is disabled).
Press the Power button.
GYSCAP
The digital display shows the GYSCAP voltage capacity.
The display shows 0 because the battery voltage is not available in this mode.
Press the button for 3 seconds to perform a forced start.
A 30 seconds countdown starts.
GYSCAP
Start the vehicle to be repaired as soon as possible before its capacity is transferred to the large
consumers.
Wait for the GYSCAP to charge until the digital display shows
(once charged, the GYSCAP is ready to be used again.
GYSCAP
GYSCAP
After stopping GYSCAP:
Disconnect the GYSCAP clamps from the vehicle.
Wind up the cables and put them in the dedicated space.
14
Translation of the original
instructions
is < 8 V at 12 V and < 16 V at 24 V. In that case, follow the BYPASS steps.
(of the vehicle)
Unplug the (+) connector from your battery's terminal and
connect the GYSCAP's red clamp (+) to it.
Connect the black clamp (-) of the GYSCAP to the (-) termi-
nal on the battery.
Hand over the set: red (+) terminal and clamp on the (+)
terminal of the battery.
Remove the red clamp (+) from the battery's (+) terminal.
GYSCAP
.