Environmental Instructions - V-ZUG Solo Instrucciones De Instalación

en
attachment holes. Now place the under tower
on the installed upper tower and fasten it
provisionally with tape. Now place the glass
plate on the hood module, lead the glass
holder through the hole in the pane and attach
it with the help of the previously loosened
screws (shift lever must be pointing forward)
Image: With Active Carbon Filter (a)
tightly to the hood module. Create the
connection between the lamps and controls
by the connector coupling, as well as the
connection between the switch and controls.
Now please insert the low voltage wiring for
the light diodes in the upper tower into the
controls. Then please install the grease filter
by turning it clockwise (recirculating hoods
are provided with an additional active carbon
filter). Remove the provisional tape fastening
and slowly lower the under tower onto the
hood. The exhaust hose must always be laid
out in a manner in which it is not bent. Be
certain to disconnect the plug from the outlet
before conducting electrical work on the
exhaust hood. Conduct a function test.
a
a
b
c
Disposal
Packaging
The packaging of the exhaust hood is
recyclable. Cardboard and polyethylene foil
(PE) are used as packaging materials. The-
se materials are environmentally compliant
and should be disposed of as per the valid
regulations of the respective location.
Environmental
Instructions
This device is labeled as per European
Directive 2002/96/EG on Waste Electrical and
Electronic Equipment (WEEE). This guideline
provides the basic conditions valid for the EU-
wide return and recycling of old appliances.
Please consult your dealer for the current
disposal methods.