Battery Pack Installation; Battery Pack Removal; Battery Charging - Senco DURASPIN DS522-18V Instrucciones De Empleo

2. Insert the threaded plate on the opposite side of tool and re-install the hook at the desired position using
locking plate and thumb screw.

BATTERY PACK INSTALLATION

CAUTION
Only SENCO VB-Series 18V batteries should be used on SENCO tools:
VB0194 (EU/UK).
1. Align battery ribs with slots on the tool.
2. Push battery until it seats tightly on the tool.
3. A click can be heard when the release mechanism seats properly.

BATTERY PACK REMOVAL

1. Depress buttons on both sides of battery.
2. Slide battery off tool.

BATTERY CHARGING

1. Place battery pack in charger.
2. Align raised ribs on battery pack with groove in charger.
3. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When
properly connected, the red light will turn on. Red flashing light indicates fast charging mode.
4. Red and green light flashing indicates defective battery pack. Return battery pack to your nearest SENCO
Authorized Service Centre for inspection or replacement.
5. Solid red light indicates that the battery is charging.
6. When your battery pack becomes 80% charged, the red light will stay on and the green light will flash. When
battery pack is fully charged, the red light will turn off and the green light will turn on.
7. After normal usage, 1 hour of charge time is required to be fully charged. A maximum charge time of 1 hour or
less is required to recharge a completely discharged battery pack.
8. The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a
problem. The battery pack houses 4 coloured LED lights. These LEDs indicate the state of charge and possible
problems inside the battery pack.
TOOL OPERATION
15
EN