Tool Operation; Adjusting For Fastener Length - Senco DURASPIN DS522-18V Instrucciones De Empleo

Tool Operation

Read sections titled "Safety Warnings" before operating tool.
For best results, charge new battery before using (see "Battery Charging" page 15).
WARNING
Do not use this product if it is not completely assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result
in serious personal injury.
WARNING
Do not attempt to modify this product or create accessories or attachments not recommended for use
with this product. Any such alteration or modification is misuse and could result in hazardous conditions possibly leading
to serious personal injury.
If any parts are damaged or missing, please call +31 320 295 575 for assistance.

ADJUSTING FOR FASTENER LENGTH

1. Remove battery before adjusting nosepiece for fastener length.
2. Depress the screw selector pin until it is flush with nosepiece and slide the nosepiece to the desired setting by
aligning hatch marks with the silver adjustment pin.
3. Release pin and make sure it is fully engaged in selected nosepiece slot for proper operation.
DS522-18V
DS222-18V DS225-18V
25mm
30mm
35mm
40mm
45mm
50mm
DS525-18V
DS322-18V
1" 1" 1"
1 1/4" 1 1/4" 1 1/4"
25mm
1 1/2" 1 1/2" 1 1/2"
1 3/4" 1 3/4" 1 3/4"
30mm
1 5/8" 1 5/8" 1 5/8"
2" 2" 2"
35mm
2 1/4"
2 1/2"
40mm
2 3/4"
3"
45mm
50mm
DS722-18V BIT TYPE
Bit Type DS222/DS225
Phillips EA0297
Square EA0298
25mm Phillips
Rex EA0299
30mm Square
35mm SENCO
40mm
45mm
50mm
55mm
65mm
70mm
75mm
11
DS522-18V/ DS722-18V
DS322
DS525-18V
EA0400
EA0401
EA0326B EA0400B
EA0402
EA0327B EA0401B
EA0333B EA0402B
EN