To Start The Engine - Porter Cable BSV550-W Manual De Instrucciones

deadly gas.
3. Make sure generator is grounded in accordance with local requirements.
4. All electrical loads MUST be disconnected.
over heat ing of at tach ments and could cause a fire. Never attempt to "speed-up" the

TO START THE ENGINE

odorless and deadly gas.
1. Open the fuel shut-off valve.
2. Move the choke control located on the engine to the "Choke" position.
NOTE: No choke is required on warm engines. make sure choke is in the "RUN"
position on warm engine starts.
3. On the engine there is a ON/OFF switch located on the front
panel of the engine. Place this switch to the "ON" position.
4. Grasp handle on rope starter and pull slowly until resistance
is felt. Let the rope rewind slowly. Pull rope with a rapid full
arm stroke. Let rope rewind slowly. Repeat if necessary.
5. When engine starts, gradually move the choke to the "RUN"
position.
IMPORTANT: Allow generator to run at no load for 5 minutes upon each initial
start-up to allow engine and generator to stabilize.
Never run engine indoors or in en closed, poor ven ti lat ed areas,
en gine exhaust contains carbon mon ox ide, an odorless and
Engine speed has been fac to ry set to pro vide safe op er a tion.
Tampering with the engine speed adjustment could re sult in
Never run engine indoors or in en closed, poor ven ti lat-
ed areas, en gine ex haust contains car bon mon ox ide, an
13 - ENG
A16596