Maintenance / Service - Skil SD12705 Serie Manual Original

charger A and charger interface B
- connect charger A with wall socket
- indicator C is blinking GREEN
indicating that the battery is being
charged
- during the charging procedure, the
handle of the tool warms up; this
is normal
- indicator C turns GREEN
continuously when the battery is
fully charged
- the lithium-ion battery can be
charged at any time (interrupting
the charging procedure does not
damage the battery)
- the lithium-ion battery does not
have to be empty before charging
(no "memory-effect" as with nickel-
cadmium batteries)
- the tool cannot be used during
the charging procedure; it is not
defective when inoperative during
the charging procedure
- if you anticipate long periods of non-
use for the tool, it is best to unplug
the charger from its power source
• On/off 9
• Changing direction of rotation q
- when not properly set in left/right
position, switch D 2 cannot be
activated
! change direction of rotation
only when tool is at a complete
standstill
• Changing bits w
- push bit to end position in bitholder
G
! do not use bits with a damaged
shank
• Automatic spindle-lock
Allows you to manually tighten or
loosen screws, when necessary e
• LED-light r
LED-light H automatically lights on
when activating switch D, even when
switch E is in the middle (locking)
position
• Bit storage J 2
Offers storage for 2 bits at the front
• Two handle positions t
• Battery protection
Switches off the tool or prevents the
tool from being switched on, when
- the load is too high
- the battery temperature is not within
the allowable operating temperature
range of -20 to +50°C
- the lithium-ion battery is nearly
empty (to protect against deep
discharge)
! do not continue to press the
on/off switch after the tool is
switched off automatically;
battery may be damaged
APPLICATION ADVICE
• Use the appropriate bits y
! do not use damaged bits
! only use bits with hexagon shaft
• When turning in a screw at/near the
cross cut end or an edge of wood, pre-
drill a hole in order to avoid cracking
of the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one
should pre-drill a hole
• For more information see
www.skil.com

MAINTENANCE / SERVICE

• This tool is not intended for
professional use
• Keep tool and charger clean
! unplug charger from power
source before cleaning
• If the tool/charger should fail despite
the care taken in manufacturing and
testing procedures, please send the
tool or charger undismantled together
with proof of purchase to your dealer.
- in case of a defective charger send
both charger and battery to your
dealer.
• Be aware that damage due to overload
or improper handling of the product
will be excluded from the warranty (for
the warranty conditions please ask
your dealer).
14