Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Congratulations. You have purchased a Regent motion activated floodlight. This
security lighting system will provide years of convenience and protection for your
home and family.
How it works
Your Regent motion activated floodlight senses heat
images from objects such as people, large animals and
automobile engines. When motion is detected, the light
will automatically turn on. Once motion has stopped, the
light will turn off after a preselected time delay. Your
motion activated floodlight may also be used as a stan-
dard floodlight.
What you need
• Phillips screwdriver
• Outdoor weatherproof silicone caulking
What's included
• Motion detector and light fixture (A)
• 300 watt quartz halogen bulb (B)
• Coverplate gasket (C)
• (4) Coverplate screws (D)
• (3) Wire nuts (E)
What to know
• For outdoor use only.
• UL and CUL LISTED for wet locations.
• This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Under Part 15 of the FCC Rules, any changes or
modifications to the motion detector described in this instruction sheet that are not
expressly approved by Cooper Lighting could void the user's authority to operate
the equipment. NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Fixture must be connected to a 120 Volt, 60 Hz, 2.5, 300 watt power source. Any
MS188, CMS188 (Bronze)
MS188W, CMS188W (White)
180 degrees
C
2
70 foot
range
A
B
D
E
Tabla de contenido
