Assembling The Vacuum Cleaner; Emptying The Dust Collector - Team kalorik TKG VC 1001 Manual De Instrucciones

Fax +32 2 359 95 50
ATTENTION: never use the handle of the dust collector to carry the appliance, but ALWAYS USE
THE CARRYING HANDLE OF THE APPLIANCE!

ASSEMBLING THE VACUUM CLEANER

•
Always remove the plug from the power socket before fitting or removing accessories!
•
Insert the hose connector into the hose connection inlet until it locks. To remove the hose,
press the release button of the hose connector and pull at the hose.
•
Fit the tube to the handle.
•
Fit the tube to the floor brush.
•
Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.
•
The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
•
The appliance is delivered with the following accessories:
OPERATION
•
Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your
foot.
•
It is advisable to set the electronic power regulator to the minimum position MIN before
switching on the appliance. By sliding the regulator button, the suction power can be
adjusted. You can also adjust the suction power by using the wind-force adjuster on the
handle of the flexible hose. Use a low suction power for furniture and other delicate
surfaces and use high suction power for fitted carpet and other floors.
AFTER USE
•
Stop the vacuum cleaner by pressing the ON/OFF switch.
•
Unplug the appliance from the power supply.
•
Simply press the cable rewind button to activate the cable rewind mechanism.
•
The carrying handle can be used to move the appliance. Never use the handle of the
dust container to carry the appliance!
•
After use we advise you to empty the dust collector to avoid smells and mildew that could
be caused by damp dust particles that may have been vacuumed, and also to
guarantee an optimal efficiency during the next use. To do so, see below.

EMPTYING THE DUST COLLECTOR

•
Press the release button of the dust container and pull the dust container out.
•
Hold the dust collector over a dustbin, press the unlocking button underneath the handle
of the dust collector to open the lower cover of the dust container and spill the rubbish.
•
Close the dust collector and put the dust collector back in the appliance until it locks in
place.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
a crevice tool: for radiators, crevices, corners, baseboards
and between cushions.
an upholstery brush: for curtains, cushions, edges, doors,
mattresses etc.
9
Assembly page 9/44
special instruction from
TKG VC 1001 - 100601
Team