Cleaning And Maintenance - Team kalorik Kitchen Originals TKG JK 1034 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Fax +32 2 359 95 50
OPERATION
Always remove the jug from the power base before filling it or before any operation.
Open the lid by turning it towards "OPEN" and remove it to fill the jug with fresh water,
paying attention not to fill above the maximum mark in the kettle. It is absolutely
necessary to respect this safety measure.
Put the lid back in place and turn it towards "LOCK" to close it correctly.
Put the jug onto the power base, plug into the wall socket and press the switch. The pilot
light will come on, indicating that the appliance is operating. If it does not come on, check
if the kettle is correctly positioned on the base and check if the base is plugged in.
The jug kettle will switch off automatically when the water is boiling. However, you can stop
the appliance any time by pressing the switch.
For instant reboiling, wait until the water has cooled down and press the switch again.
To pour the water it is not necessary to unscrew the lid, you just have to press the lever
protruding from the lid.
This thermos flask electric kettle allows you to keep the water warm for about 2 hours at
80°C and 4 hours at 68°C.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device which switches the appliance
off when it is accidentally switched on without water. Please bear in mind that only the
thermostat is switched off in case of overheat, whereas the switch stays in ON-position.
In this case, unplug the appliance and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element.
The kettle may then be used as normal.

CLEANING AND MAINTENANCE

Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
To remove scale from the inner walls of the kettle you can use a soft brush.
Never use abrasive products.
On no account must the jug kettle or its power base be immersed in water.
DESCALING
To remove scale from the jug kettle, use products made especially available for this purpose.
Make sure to use a type recommended for plastic kettles.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2012/19/EU
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/36
on the
TKG JK 1034 - 141121
Tabla de contenido
loading

Tabla de contenido