Intended Use; Tool Specifications; Declaration Of Conformity; Delivery Scope - Würth H 28-MLE Power Traducción Del Manual De Instrucciones De Servicio Original

Symbol Meaning
Switching Off
On/Off switch lock-on
Releasing the On/Off switch
Low speed/impact rate
High speed/impact rate
Tool holder
P Rated power input
1
E Impact energy per stroke according to
EPTA-Procedure 05/2009
n No-load speed
0
Ø Drilling diameter, max.
Concrete
Steel
Wood
Brickwork
Core bit
Weight according to EPTA-Procedure
01/2003
Protection class
L Sound power level
wA
L Sound pressure level
pA
a Vibration total value
h
K Uncertainty

Delivery Scope

Rotary hammer, auxiliary handle and depth stop.
Application tools and other accessories shown or described
are not part of the standard delivery scope.
A complete overview of accessories can be found in our
accessories program.

Intended Use

The machine is intended for hammer drilling in concrete, brick
and stone, as well as for light chiselling work. It is also suitable
for drilling without impact in wood, metal, ceramic and plas-
tic.

Tool Specifications

The tool specifications of the machine are listed in the table on
page 174.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries, these
values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product
described under "Tool Specifications" is in conformity with the
following standards or standardization documents:
EN 60745 according to the provisions of the directives
2011/65/EU, 2004/108/EC, 2006/42/EC.
Technical file (2006/42/EG) at:
Adolf Würth GmbH & Co.KG, PFW,
Reinhold-Würth-Straße 12-17
74653 Künzelsau, Germany
T. Klenk
General Manager
Künzelsau: 10.06.2013

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 174.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet has
been measured in accordance with a standardised test given
in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or poorly main-
A. Kräutle
General Manager
13