Hach SC4500 Manual Básico Del Usuario página 6

and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at their expense. The following techniques can be used to reduce
interference problems:
1. Disconnect the equipment from its power source to verify that it is or is not the source of the
interference.
2. If the equipment is connected to the same outlet as the device experiencing interference, connect
the equipment to a different outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
3.2 Intended use
The SC4500 controller is intended for use by water treatment professionals who measure multiple
water quality parameters in industrial water, municipal water or waste water plants. The
SC4500 controller does not treat or alter water.
3.3 Product overview
Chemical or biological hazards. If this instrument is used to monitor a treatment process
and/or chemical feed system for which there are regulatory limits and monitoring
requirements related to public health, public safety, food or beverage manufacture or
processing, it is the responsibility of the user of this instrument to know and abide by any
applicable regulation and to have sufficient and appropriate mechanisms in place for
compliance with applicable regulations in the event of malfunction of the instrument.
Network and access point security is the responsibility of the customer that uses the wireless
instrument. The manufacturer will not be liable for any damages, inclusive however not limited to
indirect, special, consequential or incidental damages, that have been caused by a gap in, or
breach of network security.
Perchlorate Material—Special handling may apply. Refer to
www.dtsc.ca.gov/hazardouswaste/perchlorate. This perchlorate warning applies only to primary
batteries (provided singly or installed on this equipment) when sold or distributed in California, USA.
The controller is supplied with a protection foil installed on the display. Make sure to remove the
protection foil before the controller is used.
The SC4500 is a 2-channel controller for digital analytical devices (e.g., sensors and analyzers).
Refer to Figure 1.
The controller shows sensor measurements and other data on the display, can transmit analog and
digital signals, and can interact with and control other devices through outputs and relays. Outputs,
relays, sensors and modules are configured and calibrated through the user interface on the front of
the controller or remotely for network connected controllers. The controller connects to Claros with a
5 cellular network , WiFi network
shows the status of maintenance tasks and gives the status of the instrument condition.
The instrument display is a touch screen. The instrument enclosure has a protective vent in the
bottom. Do not cover or remove the protective vent. Replace the protective vent if damage is seen.
6 English
D A N G E R
N O T I C E
N O T I C E
N O T I C E
5 or through LAN connection. The Prognosys diagnostic system 5