Troubleshooting - Imetec Q5901 Instrucciones De Uso

PROBLEMS
EN
The vacuum-packer machine
doesn't switch on
The vacuum-packer machine
doesn't complete the creation
of a vacuum in the bags.
The bag is no longer held up
once it has been sealed.
The vacuum-packer machine
doesn't take the food up
properly from the containers
In some cases, a program
might undergo an error and
cause a machine fault
18

TROUBLESHOOTING

• Make sure the machine is correctly connected to a socket
with an earth connection.
• Make sure the power cable isn't damaged. Don't use the
machine if the cable is damaged.
• To take in and seal correctly, the edge of the bag must be
on the sealing bar. Check that the open side of the bag is
in the basin, and that the bag isn't wrinkled on the sealing
bar.
• In the case of bags on a roll, make sure the first seal is
complete and that there is no discontinuity in the seal.
• For the vacuum procedure to be carried out properly, the
machine and bag must be clean, dry and free of residue.
If necessary, clean the surface of the sealing bar and then
try again.
• Sharp objects may produce small holes in the bags. To
avoid this, cover the sharp edges with a paper napkin. You
are advised to round the edges of hard foodstuffs such as
cheeses.
• Some foods may release gases if they aren't suitably
treated or frozen before being vacuum packed, and this
will cause them to deteriorate. If this happens, you are
advised not to eat the food. Throw it away.
• The accessories tube may not be properly connected.
Make sure the tube is fully inserted in the jar lid and the
accessory connection, then try again.
• Leave enough space in the upper part of the jar.
• Make sure the jar and lid aren't damaged; small cracks
sometimes form in the containers. When this happens, the
container is no longer airtight and mustn't be used.
• Switch the machine off and take the power cable out of
the socket. Reconnect the power cable and switch the
machine back on.
SOLUTIONS