Uline H -7621 Manual De Instrucciones página 2

CLAMP MOUNTING
1
Clamp
Mounting
Bracket
5
Tighten
NOTE: Clamp mount is compatible with desk
thickness of 3/4 – 4¾".
1. Attach clamp mounting bracket (2) to bottom of
monitor arm base using M6 x 12 mm bolts (C) and
4 x 4 Allen wrench (F).
2. Apply anti-slip foam for base (5) to bottom of monitor
arm base.
3. Apply anti-slip foam for clamp (3) over metal points
on clamp (4).
GROMMET MOUNTING
Figure 3
2
1
Grommet
Bolt
M6 x 12 mm Bolts
Grommet Mounting Plate
NOTE: For grommet mounting, hole in desk
must be 3/8 – 2¾".
NOTE: Grommet mount is compatible with desk
thickness of 1 – 3⁄".
1. Insert grommet bolt (7) through center of grommet
mounting plate (6); counterbore-side down.
2. Attach grommet mounting plate (6) to bottom of
monitor arm base using M6 x 12 mm bolts (C) and
4 x 4 Allen wrench (F).
PAGE 2 OF 12
ASSEMBLY CONTINUED
2
Anti-Slip
Foam for
M6 x 12 mm
Base
Bolts
4 x 4 Allen
Wrench
Monitor Arm
Desk
Anti-Slip
3
Foam
for Base
3
Metal
Points
Knob
Base
NOTE: Select the appropriate mounting holes
based on the thickness of the desk.
4. Attach clamp (4) to the clamp mounting bracket (2)
using M6 x 14 mm bolts (D) and 4 x 4 Allen wrench (F).
5. Place clamp mounting bracket and clamp over
desk and fully tighten knob.
4
3. Apply anti-slip foam for base (5) to bottom of monitor
arm base.
4. Insert grommet bolt (7) into hole of desk.
5. Apply anti-slip foam for bottom support (8) to bottom
support (9).
6. Thread grommet bolt (7) through bottom support (9)
and attach knob (10) to end of bolt. Fully tighten
knob.
4
Anti-Slip
Foam for
Clamp
Clamp
Mounting
Bracket
Mounting
Holes
5
Anti-Slip Foam
for Bottom Support
Hole
Knob
Bottom
Support
M6 x 14 mm
Bolts
Figure 2
6
Tighten
0521 IH-7621