■ Master control section
L
K
00 –20 –15 –10 –6 –3
R
STEREO GRAPHIC EQUALIZER
+12
9
6
3
0
3
6
9
–12
100
MIXER
G
0
AUX SEND 1
F
0
AUX RETURN 1
L
E
4
Downloaded from:
http://www.usersmanualguide.com/
PHANTOM
0
+2 +4 +6
PFL
+12
9
6
3
0
3
6
9
–12
400
1k
5k
10k
10
0
10
AUX SEND 2
10
0
10
0
10
AUX RETURN 2
TAPE IN
TO
MONI
STEREO
R
0
10
10
MONITOR
5
0
5
0
10
10
PHONES
15
20
30
00
E ST L, R master control
These faders adjust the final level of all channels, and
output the combined signal to the ST OUT jacks. The
OUTPUT LEVEL L, R meters allow you to monitor the L
and R outputs.
F AUX RETURN 1-2 controls
The knobs control the input levels from the effect units
etc. connected to AUX RETURN. Since the signals input
at AUX RETURN pass through this control and are then
J
output from the ST OUT jacks, AUX RETURN can be
used not only to input the signals from effect units but also
I
as supplementary inputs.
L/MONO
AUX RETURN
1,2
H
–10dB
R
G AUX SEND 1, 2 controls
These knobs adjust the level of the signals that are output
to AUX SEND 1 and 2.
H Graphic equalizer (5 band)
Since this equalizer is placed before ST OUT, it allows
L
you to make fine adjustments in equalization to the overall
output, for sound field compensation or to prevent
feedback.
M
I PFL indicator
This indicator will light when a PFL switch is turned ON.
N
J PHANTOM indicator
This indicator will light when the PHANTOM switch is
ON.
K OUTPUT LEVEL L, R meters
O
These meters indicate the output level to the ST OUT
jacks.
L TAPE input control
This knob controls the input signal of the tape deck etc.
P
that is connected to the TAPE IN jacks.
M TAPE INPUT select switch
This switch selects the destination of the input signal of
the tape deck etc. that is connected to the TAPE IN jacks.
OFF: sent to the stereo bus
ON: sent to MONI OUT (L, R)
N MONITOR control
This knob adjusts the output level from the MONI OUT
jacks.
O PHONES control
This knob adjusts the volume of the headphones
connected to the headphone jack.
HA
AUX RETURN 1,2
HA