KRESS 360 BPS BiPower Manual De Instrucciones página 20

39694_BA_360BPS.book Seite 20 Mittwoch, 18. April 2012 9:45 09
20 English
Note: For more exact assessment of the vibration
during a specific period of operation, the times at
which the tool is switched off or still running but not
EN
actually in use should also be taken into consider-
ation.
This may significantly reduce the exposure level
over the total working period.
Define additional safety measures to protect the
operator against the effects of vibration, for exam-
ple: servicing of the power tool and tool inserts,
keeping hands warm, organisation of work process-
es.
n = No-load speed
0
n = Rated speed
1
in rpm
Individual impact strength in accord-
ance with EPTA-Procedure 05/2009
Number of impacts n
EPTA 05/2009
Corner dimension in mm
Collar diameter in mm
Weight in kg
Your device is fitted with an SDS-plus
automatic locking device.
Drilling and hammer drilling in con-
crete - max. ø in mm
Drilling and hammer drilling in brick -
max. ø in mm
Drilling and hammer drilling in sand-
stone - max. ø in mm
Drilling in steel - max. ø in mm
Drilling in aluminium - max. ø in mm
Fitting screws in wood - max. ø in
mm
360BPS-EN / 1205
The machine is radio and TV interference-free in
accordance with EN 55014-1 and interference-
proof in accordance with EN 55014-2.
4. Operation
-1
Start up, mains operation
Before putting the tool into operation, check that
the mains voltage and frequency on the type plate
match the details of your mains supply.
Fit the additional handle
Connect mains cable module if necessary
Insert battery. Battery pack must remain inserted
and is charged during mains operation.
Drilling in wood - max. ø in mm
Drilling in wood with auger bit - max.
ø in mm
Your electrical tool is double-insu-
lated in accordance with EN 60745;
For this reason an earth wire is not
required.
Before carrying out any work on the
machine, pull the main plug.
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acci-
dental starting of the power tool.
Observe correct main voltage!
Use of extension cables: Use only
extension cables approved for the
application range and with an ade-
quate cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged extension cables.
Operation