Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step 3: Attach panel F and G as shown in Fig. C.
Step 4: Attach panel C to panel B with 3 KD screws. See Fig. D.
Step 5: Attach panel A to panel C with 3 KD screws. See Fig. E.
Fig. C
BACk
Fig. D
BACk
Fig. E
BACk
Step 6: Attach panel A to panels E with 4 KD screws. See Fig. F.
Step 7: Tighten all KD screws.
Step 8: Carefully move the assembled unit to the desired location. The fireplace mantel
should not be positioned in area exposed to direct sunlight.
OPErAtiON
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP / 120 Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
wARNINg: dO NOT TOuCh. hOT suRfACe AT CeNTRe Of gRIll. hOld lefT OR
RIghT sIde Of The gRIll wheN PullINg OuT.
0/I: Press this button for main power function. The indicator light will turn on.
: Press this switch once the unit becomes energized and you can select the
following functions as desired. Press this switch again, the unit will be OFF and
enter standby mode.
3
Fig. F
fRONT
Tabla de contenido
