Complete Conversion - Whirlpool L0801665 Instrucciones De Instalación

2. Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Three LP gas
spuds are stamped "88" and one "96."
3. Remove natural gas orifice spuds using a 7 mm combination
wrench.
4. Install LP gas orifice spuds using a 7 mm combination
wrench.
©
To Convert Oven Burner
1. Open oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner air
shutter.
3. Locate LP gas orifice spud stamped "56" in literature package
supplied with range.
A. Spud
B. Holder
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners or 3 standard burners and
1 power burner. Spud size/location remain the same.
For TGP310 models:
A. Air shutter
4. Use a 3/8" combination wrench and remove the natural gas
orifice spud.
5. Install the number "56" LP gas spud.
IMPORTANT: Do not over tighten.
A_ ......
Std burner88 Std burner 88
Std bumer88 Std burner 88
For TGP314/FGP314 models:
Std burner88 Std burner 88
II II Ill
Powerburner 96 Std burner 88
5. Place the natural gas orifice spuds in the parts bag for future
use and keep with bag containing literature.
6. Reinstall burners, burner caps and burner grates.
A. LP even orifice spud stamped with "56"
6. Place natural gas oven burner spud in plastic parts bag along
with natural gas cooktop burner spuds for future use and
keep with bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.
1. Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2. Turn the manual shutoff valve in the gas supply line to the
open position.
3. Refer to the "Check Operation" section for proper burner
ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame 1/4" to 1/2" (6.4 mm to 13 mm) long. The outer
cone is not as distinct as the inner cone. LP gas flames have
a slightly yellow tip.
4. Close the broiler door and turn the knob to "OFF".
5. Refer to the "Complete Installation" section to complete this
procedure.
13