Tabla de contenido
Training and Operating Instructions
>
>
>
>
>
>
30
GB
Exercising functions
scan function during training
Adjustment: manual
>
With "Display", the data in the dot display area switches in
the following succession: Time / SPM. / Str. / Brake / Dist.
/ Power / Energy / Pulse / (Profile) / Time ...
Adjustment: automatic (SCAN)
>
Keep the button "DISPLAY" pressed until the symbol SCAN
appears. The data displayed switches at 5-second intervals.
The SCAN function is ended by pressing the "DISPLAY" but-
ton again, by the Recovery function or by an interruption in
>
exercising.
Adjustment of the resistance profile
If the resistance is changed while the program is running,
the change takes effect to the right, starting with the flashing
column. The columns to the left show the strain stages alrea-
dy covered and remain unchanged.
Power display (POWER / MAXPOWER)
During exercising, the power display can be switched from
the average value "POWER" to the peak value "MAXPO-
WER".
• Select with "SET".
The average power is always shown in the middle display.
Interval or end of exercising session
If less than 10 strokes per minute are executed or the button
"RECOVERY" is pressed, the electronics assume that exer-
cising has been interrupted. The exercising data achieved
up to that point are displayed. Strokes per min. brake
stage, power and pulse (if pulse measurement is activated)
are represented as average values by the symbol Ø.
Press "Plus" or "Minus" to switch to the current Display.
The exercising data are displayed for 4 minutes. Do not
continue exercising or press any button during this time. The
electronics switch to slumber mode.
Resumption of exercising
If exercising is resumed within 4 minutes, counting upwards
or downwards from the last value continues.
Note:
Tabla de contenido
