Ryobi EDP-5530L Manual De Utilización página 29

GB
F D
ASSEMBLY
If lag bolts are used, make sure they are long enough to
go through holes in drill press base and material the drill
press is being mounted to. If machine bolts are used,
make sure bolts are long enough to go through holes in
drill press, the material being mounted to, and the lock
washers and hex nuts.
Note: All bolts should be inserted from the top. Install the
lock washers and hex nuts from the underside of the
workbench. Once the drill press is securely mounted on a
sturdy surface perform the following:
Check for vibration when the motor is switched ON.
■
Adjust and retighten the mounting hardware as
■
necessary.
Check the table assembly to assure smooth
■
movement up and down the column.
Check to assure that the spindle shaft moves
■
smoothly.
INSTALLING / USING THE SPINDLE LOCK
LEVER (Fig. 13)
The spindle lock is installed by aligning the threaded post
on the lock lever (14) with the hole on the left side of the
tool then turning the post clockwise. Securely tightening
the spindle lock lever (14) locks the spindle in place.
Turning the lock lever counterclockwise will loosen
the spindle.
CHECKING / ADJUSTING LASER ALIGNMENT
(Fig. 14)
Check the laser alignment to ensure the intersection of
the laser lines is precisely at the spot where the drill bit
meets the workpiece. If it is not, the laser lines should be
adjusted using the laser adjustment knobs (j) located on
opposite sides of the head assembly.
Mark an "X" on a piece of scrap wood.
■
Insert a small drill bit into the chuck and align its tip to
■
the intersection of the lines of the "X".
Secure the board to the table.
■
Turn on the laser and verify the laser lines align with
■
the "X" on the workpiece.
If the laser lines do not align, loosen the set screws
■
on each of the laser housings (k) with a hex key and
rotate the laser adjustment knobs (j) until the lines
meet in the centre of the "X". Retighten the set
screws (l) to secure.
E I P NL S DK N FIN
English
WARNING
Use of controls or adjustments or performance of
procedures other than those specified herein
could result in hazardous radiation exposure.
WARNING
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating power tools.
Failure to do so could result in objects being
thrown into your eyes resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Drilling in wood.
■
Drilling in ceramics, plastics, fiberglass, and laminates.
■
Drilling in metals.
■
POWER SWITCH (Fig. 15)
Your drill press is fitted with a NVR switch. This means
that the power supply will be interrupted during the use of
the switch and will automatically default to the OFF
position.
To turn the drill press off:
Open the cover and press the red button down to
■
turn OFF O.
To turn the drill press on:
Open the cover and press the green button down to
■
turn ON I.
In case of emergency, the drill press can be stopped by
pushing the big Red button on the outside cover.
This serves as a security, quick OFF button.
SELF-EJECTING CHUCK KEY (Fig. 16)
The self-ejecting chuck key ensures the chuck key (26) is
removed from the chuck before the drill press is
turned on.
21
GR H CZ RUS RO PL