Tools Needed; Maintenance And Care - Schumacher Electric ELITE SE-1555A Manual De Instrucciones

BATTERY SIZE/RATING
SMALL Motorcycle, Garden
BATTERIES
Tractor, etc.
200 - 35 CCA
CAR/TRUCKS
35 - 550 CCA
550 - 875 CCA
MARINE/
DEEP CYCLE
K. ASSEMBLY INSTRUCTIONS
It is important to fully assemble your charger before use. Follow
these instructions for easy assembly.
PARTS
Two, 0 -32 thread cut ting
screws
Two, /4 -20 thread cutting
screws
Two wheels
One axle
Two axle caps
Two axle brackets
One handle
One handle clamp rod
One handle grip
One mounting foot
Attach Foot:
Remove charger from packing materials and place charger face
down. Attach mounting foot and secure with the two, /4-20 thread
cutting screws provided.
Axle Assembly:
Hold axle upright on floor or work surface. Then, using a hammer,
tap one of the axle caps onto the top end of the axle. Be sure to tap
the hub on straight. Slide both wheels onto the axle with the hubs
facing inward. Tap the other axle cap onto the opposite end of the
axle and place the axle assembly onto the bottom of the charger.
CHARGE RATE/CHARGING
TIME - HOURS
2 AMP 20 AMP
6 - 2 AH 2 - 4 NR
2 - 32 AH 4 - 0 NR
40 - 60 RC  - 4 90-20 min.
60 - 85 RC 4 - 8 20-50 min. 40-45 min.
85 - 25 RC 8 - 35 2.5 - 4.5 hrs.
80 RC 8 30 min.
40 RC 27 3.5
60 RC 30 4.0
80 RC 33 4.5
TOOLS NEEDED
3/8" wrench (for mounting
foot)
5/16" wrench (for wheels)
Hammer
Screwdriver (for handle
assembly)
Axle Assembly:
Place the charger on its side. Place one end of each bracket into
slot, then place the axle assembly under each bracket. Fasten
55 AMP
the other side of each bracket using the two, 0-32 thread cutting
NR
screws provided.
NR
30-40 min.
45-90 min.
20 min.
3
3.5
4
Handle:
Turn the charger right side up onto its foot and wheels. Verify grip
and handle clamp rod are installed on the handle. Remove the two
top screws from each side of the charger. Align the handle so the
screw holes are aligned with the screw holes on each side of the
wheel charger. Attach handle using the same screws.
L. MAINTENANCE AND CARE
A minimal amount of care can keep your battery charger working
properly for years.
1. Clean the clamps each time you are finished charging. Wipe
off any battery fluid that may have come in contact with the
clamps to prevent corrosion.
2. Coil the input and output cords neatly when storing the charger.
The cords can be wrapped around the handle of the charger.
This will help prevent accidental damage to the cords and
charger.
3. Occasional cleaning of the case of the charger with a soft cloth
will keep the finish shiny and help prevent corrosion.
6