Instructions For Use; Before Initial Operation; Inserting/Replacing The Battery - Flex PD 2G 18.0 Instrucciones De Funcionamiento Originales

Instructions for use

Before initial operation

 Unpack the power tool and accessories
and check that no parts are missing or
damaged.
 Attach the belt clip and bit holder with the
enclosed screws.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. See "Charger/Charging
process".
Fitting/removing the auxiliary
handle (PD 2G/DD 2G)
CAUTION!
Use auxiliary handles if these are supplied
with the power tool. The loss of control may
result in injuries.
20

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts - explosion
and fire hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
PD 2G / DD 2G / ID 1/4"