Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Section 3. Operating the appliance
3.1. Switching on the Appliance
Allow the appliance to stand upright for a mínimum of 4 hours befare you
switch it on.
Plug
in
the
supply. Set the thermostat control to the required setting as detailed in the
Temperature Control section (3.2).
Leave the appliance for approximately 4 hours for the correct temperature to
be reached.
3.2. Temperatura Control
The temperature selector knob is located on the lamp unit inside the refrigerator
(see Description of the Appliance on page 2).
Setting "O": Unit Off
Setting "MIN": Unit On- Warmest Temperature
Setting "NORMAL": Normal Operation (adequate for most situations)
Setting "MAX": Coldest Temperature
lmportant!
During high ambient temperatures e . g. on hot summer days, it may be necessary
to set the thermostat to the coldest setting .This may cause the compressor
to run continuously in order to maintain a low temperature in the cabinet.
3.3. Normal Operating Sounds
You may hear faint gurgling or bubbling sounds when the refrigerant is pumped
to the cooling system and through the coils or tubing at the rear of the
appliance. When the compressor is in operation you may hear a slight whirring
sound or pulsating noise.
compressor, and you may hear a slight click as it cycles in and out.
appliance
and
(� ))
NORMAL
The thermostat controls the operation of the
5
switch
on
at
the
mains
V.1
Tabla de contenido
