Gebrauchsanleitung und reguläre
DE
wartung
FR
Mode d'emploi et entretien ordinaire
Instructies voor gebruik en
NL
regulier onderhoud
Turn the switch off when the water tank is empty, when travelling and during the night.
IF THE TEMPERATURE IS BELOW ZERO, it is absolutely essential to empty the entire
water plant.
Drain all of the water from the tank by opening the discharge outlet.
If there is no discharge outlet, open one tap leaving the pump in operation until the tank is
empty.
Take the suction pipe off from the pump, and leave it on for a while with the taps open.
Fiamma pumps can operate in any position. In case of vertical mounting we recommend
installation by placing the motor on top and the head below to prevent possible damage
caused by leaks.
Fiamma pumps include anti vibration base plate in order to reduce noise and vibrations, and
so we recommend to install them on a solid surface.
Due to their technical features, Fiamma pumps can be installed up to 9 mt away from the
tank outlet.
Use with water at a temperature between + 4 ° C / + 40 ° C.
Cleaning the fi lter: periodically (and always at the beginning and in the end of each
season) disconnect the rubber holders and unscrew the 4 (fi g. A) screws.
Remove the fi lter cover and then remove the stainless steel covering net.
Wash the net with a jet of water (Fig.B). When you reassemble it, be very careful in
positioning the seal so as to avoid water or infi ltrations of air leaking into the pump,
when you reassemble the transparent fi lter cover, be sure you use the already
existing thread. Turn the screw one-fourth of a turn in the opposite direction and
then screw it in (fi g. C). For a good functioning, there should not be any air
infi ltrations in the system. The battery must be > 10 Volt.
OPEN
A
EN
ES
IT
B
Comfort
Uses instruction and
routine maintenance
Instrucciones de uso y
mantenimiento ordinario
Istruzioni d'uso e
manutenzione ordinaria
CLOSE
C
7
