Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FLEX ADM 60–T
Inserting/changing batteries ................... 170
Switching the device on and off ............. 172
Setting unit of measurement .................. 174
Selecting reference point ....................... 176
Setting measuring mode ........................ 178
Linear measurement .............................. 180
Area measurement ................................ 182
Volume measurement ............................ 186
Single Pythagorean ............................... 190
Double Pythagorean .............................. 194
Using the memory .................................. 198
Continuous measurement ...................... 200
Maximum/minimum measurement ......... 202
Addition and subtraction ........................ 204
Checking precision ................................ 208
Error message on the display
Error code
001
The reflected laser beam is too intense.
➜ Do not aim at highly reflective surfaces;
if required cover (e.g. with paper).
002
Measurement range exceeded.
➜ Take measurements within the range
of 0.1 to 60 m only.
16
Cause
➜ Remedy
The target aimed at reflects the laser beam not
003
enough. ➜ Aim at a different target; if required
cover (e.g. with white paper).
004
Temperature too high. ➜ Wait until operating
temperature (0 °C ... 40 °C) has been
reached.
005
Temperature is too low. ➜ Wait until operating
temperature (0 °C ... 40 °C) has been
reached.
006
Batteries too weak. ➜ Insert new batteries.
007
Strong vibrations or quick movement while
taking the measurement. ➜ Do not move
the measuring instrument while taking
the measurement.
008
Incorrect input for Pythagorean measurement.
➜ Observe the order of the displayed
measured sections.
Checking precision
It is recommended to check the device
regularly to ensure that it is always precise.
If the precision deviates from the permitted
tolerance range, the device must be taken
to a customer service workshop authorised
by the manufacturer.
Capítulos
Tabla de contenido
