Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the hedge shear blades
1
1. Crank
2. Undercover
3. Shear blades
010904
Prepare the crank, the undercover and new shear
blades.
1
1. Basic alignment line on the tool housing
2. Pins
010905
Adjust the three detent pin position so that these three
pins are aligned with the basic alignment line on the tool
housing.
1. Recessed part of crank
2. Crank
3. Apply grease
4. Pins
015809
2
3
2
1
2
3
4
Fit the crank with its recessed part facing downward
onto the detent pins. At this time, apply a small amount
of grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
1. Oval holes that are overlapped
2. Hole in the base plate of shear blades
3. Base plate
010907
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
010908
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
010909
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
12
1
2
1. Blade cover
1
1. Bent part of the
base plate of
shear blades
3
Tabla de contenido
