Remington i-LIGHT IPL5000 Manual Del Usuario página 6

Test the i-Light device on your skin
1. Review the Warnings and Safety Precautions.
2. Familiarize yourself with the features of the i-Light device.
3. Consult the Skin Tone Chart to ensure your skin color is in the
acceptable range.
4. Test the i-Light device on a small patch of skin and wait 48
hours to ensure there are no adverse reations.
]
5
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils,
deodorants, perfume, make up, lotions and creams. Shave the
hair from the area to be treated.
2. Never use wax, epilation, tweezers, or depilation products to
remove the hair because they counteract the IPL process.
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest
the hand piece in the base cradle. Locate the power switch
on the i-Light base and ensure the unit is OFF. Connect the
power cord to the i-Light base at the power inlet. Connect the
power cord to the wall outlet. Turn the power switch ON
(fig 6).
4. Select the desired Intensity Level. If the Multi-Flash Mode is
desired, turn ON using the Flash Mode Selector Button (fig 7).
12
100827_REM_IFU_IPL5000_21L GB12-GB13 100827_REM_IFU_IPL5000_21L GB12-GB13
(fig. 5)
48
h
]
6
]
7
Treat desired area(s) with the i-Light device –
Single Flash Mode
1. Place the i-Light hand piece against your skin so the Flash
Window is flush with the skin surface (fig. 8).
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb
Status Indicator Display is illuminated.
3. Press the Flash Button to activate the device (fig. 9).
4. Move the hand piece to a new treatment area and repeat
steps 1-3 (fig. 10).
Treat desired area(s) with the i-Light device –
Multi Flash Mode
1. Place the i-Light hand piece against your skin so the Flash
Window is flush with the skin surface (fig. 8).
2. Ensure the Skin Contact Sensor is fully engaged and the Bulb
Status Indicator Display is illuminated.
3. Press AND HOLD the Flash Button down to activate the
device (fig. 9).
4. Immediately after the device has flashed, slide the hand piece
to a new location. After a short delay (approximately
2 seconds) the device will flash again (fig. 10).
NOTE: ■ During Multi-Flash Mode, the Skin Contact Sensor
AND the Flash Button must remain fully depressed.
If either becomes disengaged, the device will not
operate. To resume treatment, repeat steps 1-4.
■ During Multi-Flash Mode, the Bulb Status Indicator
Display will remain illuminated while the Skin
Contact Sensor and Flash Button are engaged.
]
8
]
9
]
10
13
05.11.10 13:25 05.11.10 13:25