Remote Display - Stanley FAT MAX FMHT1-77360 Manual De Usuario

GB
User Manual
Remote Display Plumb LEDs- Press the power button momentarily to select remote display Plumb LEDs ON or OFF.
On is solid, Off is flashing. After 5 seconds of inactivity, the remote display will exit menu mode and the setting will be
saved until unit is turned off.
Plumb
LEDs
Operation
Sets of LEDs will flash quickly as shown below when in the modes shown.
If the laser goes above or below the receiver, the last set of LEDs to detect the laser will flash slowly.
Grade Detection
Same for receiver and remote display
Receiver
too high
or lost
beam
Plumb Detection
Excavator bucket position as shown.
Out Plumb In
LED LED
Flashing Solid
Green Green
Receiver
Troubleshooting
No Signal to Remote-
Note: The remote and receiver must be in communication for the menu to be accessed on the remote.
6
LEDs ON
9 Channels
(see dots)
Receiver
on grade
7 Channels
(see dots)
L
Out
LED
Flashing
Red
Red

Remote Display

• Receiver out of range
• Receiver turned off
• Receiver on a different communication channel
LEDs OFF
Yellow
Yellow
Green
Red
Red
Receiver
too low
or lost
beam
L
Plumb In
Green Red