Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ADJUSTMENTS
Lateral guide discs
16.5.2 Adjusting lower saw band guide
The upper saw band guide consists of the following components:
Rear thrust bearing
Lateral guide discs
Rear thrust bearing
Lateral guide discs
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BAS205 /
ZI-BAS25045
The lateral guide pins should slightly strip the saw
band to obtain a vibration-free and straight cut.
Procedure:
To adjust, loosen the clamping nuts (CN) and
press the lateral guide discs (GD) up to 0.5 mm
to the saw band.
Then retighten the clamping nuts (CN).
Procedure:
Loosen the two screws (M6x20) and nuts (N).
Remove the u-shaped clamp (C) from the
worktable.
To disassemble the worktable from the bench
angle gauge (AG), loosen the three screws
(M6x16), washers and nuts (N).
Raise the upper blade guide fully (see 16.6).
Loosen the two locking screws (LS) and
remove the bench angle gauge (AG).
Open the lower front door (F).
To adjust, loosen the clamping screw (CS) and
position the rear thrust bearing (TB) at a
distance of about 0.5 mm from the saw band
back.
Then tighten the clamping screw (SC) again.
Procedure:
To adjust, loosen the clamping nuts (CN) and
press the lateral guide discs (GD) up to 0.5 mm
to the saw band.
Then retighten the clamping nuts (CN).
45
Tabla de contenido
