Federal Signal Corporation 121 Hoja De Instrucciones página 2

INSTRUCTION SHEET FOR FEDERAL MODELS 121 (12VDC),
Installation, maintenance and disposal of this product must be carried out in
accordance with national codes and standards.
It is important to follow all instructions shipped with this product. This device is to be
installed by a trained electrician who is thoroughly familiar with and will follow all
applicable national and local codes in the country of use.
This device should be considered a part of the warning system and not the entire
warning system.
The selection of the mounting location for the device, its controls and the routing of the
wiring is to be accomplished under the direction of the facilities engineer and the safety
engineer. In addition, listed below are some other important safety instructions and
precautions you should follow:
• Read and understand all instructions before installing or operating this
equipment.
• Do not connect this light to the system when power is on.
• After installation, ensure that all set screws are properly tightened.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
• Establish a procedure to routinely check the light installation for integrity
and proper operation.
Failure to follow all safety precautions and instructions may result in property damage,
serious injury, or death to you or others.
I. GENERAL
Model 121 is only available for 12Vdc.
Model 121A is available for 12Vdc and 24Vdc.
Model 121S is available for 120Vac, 50/60 Hz.
II. UNPACKING.
After unpacking the unit, examine it for damage that may have occurred in transit. If
the equipment has been damaged, do not attempt to install or operate it, file a claim
immediately with the carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying them.
121A (12VDC AND 24VDC), AND 121S (120VAC)
VITALITE® ROTATING LIGHTS
SAFETY MESSAGE TO INSTALLERS
NOTE
-1-