Use; Mounting/Adjusting The Blade Guard; Fitting The Additional Handle; Fitting/Changing The Roughing/ Cutting Disc - Kompernaß PARKSIDE PWS 230 D4 Traducción Del Manual De Instrucciones Original

Use

Mounting/adjusting the blade guard

WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
RISK OF INJURY!
► Always use the angle grinder with the blade
guard . The blade guard should be fitted
securely. Set it so that the highest possible
degree of safety is achieved, i.e. the smallest
possible part of the grinding disc is open to
the operator. The blade guard
to protect the operator from fragments and
accidental contact with the grinding tool.
RISK OF INJURY!
► Make sure that the blade guard
least at the same angle as the additional
handle (see fig. B). Otherwise, you could
cut injure yourself on the roughing disc or
cutting disc.
♦ Put the protective cover in the position shown
(see Fig. F).
The protective cover can only be put on or
removed in this position.
Turn the protective cover until it clicks into place
for the first time.
♦ Now pull the lever
cover into the required position (working
position) until it clicks into place.
♦ Check the secure seat of the protective
cover. The lever
guard must not twist.
■ 10 │ GB │ IE
is designed
is fitted at
and turn the protective
must be engaged and the

Fitting the additional handle

CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle
Failure to do this can lead to serious injury.
The additional handle
onto the left or the right depending on the job
at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/rough grinding discs. Roughing and
cutting discs become very hot. Allow them to cool
down completely before touching them.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
mounting flange without any play. Do not use a
reducer or adapter.
■
Check the roughing/cutting disc. It should not
be damaged or damp, and it should have no
cracks. Otherwise, it could break during use
and cause injuries.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle
at a complete standstill.
♦ Press the spindle locking button
spindle.
♦ Undo the clamping nut
mounting spanner
♦ Place the rough grinding or cutting disc with the
label side towards the appliance on the
mounting flange
♦ Then replace the clamping nut
side facing up on the mounting spindle
.
can be screwed
to lock the
using the two-hole
(see fig D).
.
with the raised
.
PWS 230 D4
is