Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
The powerstrip cord is shipped inside the upper tray area and
■
must be routed through the rubber grommet located on the
rear of the tray area.
Open the tray lid, remove the power cord packaging material,
■
and push the cord power plug through the grommet. Pull the
cord through completely.
A second grommet is located in the back of the tray area and
■
can be used to route additional cords if needed.
Always unplug power cord when moving or cleaning the tool
■
storage combo.
Do not insert a cord through a hole without a grommet.
■
The powerstrip includes an On/Off switch that has an
■
overload protector rated at 15 A. Do not overload the
powerstrip.
The USB ports can be used to charge cell phones and power
■
USB devices.
In the back of the upper tray area is a magnetic tool holder that can be used to hold small tools, that are most used, for easy access.
■
TOOL CHEST COMBO MAINTENANCE
Always unplug and remove all cords before cleaning the tool combo.
■
The tool storage combo can be cleaned with a mild detergent and water.
■
The drawer slides and casters can be lubricated with high-quality bearing grease.
■
Remove any grease / oil with a nonflammable cleaner.
■
There are many benefits to registering your product. Find out more and register your product online at:
www.gladiatorgarageworks.com.
Consumers in Canada can call 1-800-807-6777.
In U.S.A. call 1-866-342-4089.
10-Apr-2020 12:07:31 EDT | RELEASED
POWER OUTLET WITH USB
WARNING
MAGNETIC TOOL HOLDER
REGISTERING YOUR PRODUCT
In some European factories the letter "W" of the part code mentioned herein will be automatically
NOTE: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different
■
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
■
help.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
7
Tabla de contenido
