Final Assembly - Gladiator GATC4115JG Instrucciones De Ensamblaje

Ocultar thumbs Ver también para GATC4115JG:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Using two or more people, lift the cabinet up and onto the casters.
1.
Bumper Assembly
F4
F5
F4. 6 mm washer
F5. M6 Hex-head
bolt
Using 6 mm Hex-head bolts (F5) (8) and 6 mm washers (F4) (8),
fasten a bumper to each corner of the cabinet. Completely tighten
all the fasteners.
NOTE: To keep from stripping the bolts, do not overtighten.
3.
Use, Remove and Replace
the Drawers
NOTE: The key locks the lid and all of the drawers. Use the
drawer liners to avoid scratching or damaging the drawers.
REMOVING THE DRAWER
Unload the contents from the drawer. Slide out the drawer as far
as it will go. Press the lever down on the right-hand track and lift
the lever up on the left track to release the drawer. Pull the drawer
out the rest of the way.
REPLACING THE DRAWER
Align the drawer guides with the receiving glides. Hold the
receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed.
Push the drawer in completely.
6
10-Apr-2020 12:07:31 EDT | RELEASED

FINAL ASSEMBLY

WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
F5
F4
A
A. Lever
In some European factories the letter "W" of the part code mentioned herein will be automatically
2.
LED Light Assembly
Cable clip
The included LED light is used to illuminate the upper chest tray
area. The LED light is magnetic and may be positioned anywhere
on the inside flat surface of the lid. The LED light is powered by
the USB port on the powerstrip. Route the included USB cable
as shown. The wire should be positioned behind the center lid
support. Use the two self-adhesive cable clips to hold the USB
cable in position as shown. After assembly, make sure the lid
closes and the USB cable stays within the tray area and does not
contact the hinge, lid opening, or any moving parts.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
LED light
Cable clip
USB cable
Tabla de contenido
loading

Tabla de contenido