Handle Installation; Hose Connection - Pfister Marielle LF 49 Serie Manual De Instrucciones

7
7E
7D
7A
7B
7C
7G
7E

7 HANDLE INSTALLATION

Thread Valve Adapters (7A) onto Valve End Bodies (7B) and tighten so that the Valve Adapters
(7A) sit on the surface of the Valve Body Washers (7C). Place Plastic Seal Rings (7D) against
the bottom of Handle Hubs (7E). Connect Handles (7F) onto Valve Adapters (7A).
Be sure Valves and Levers are in the "OFF" position. Secure handles by holding the
Lever (7G) in place and tighten the Hubs (7E) by rotating them in a clockwise direction.
To remove handles, rotate Hubs (7E) in a counterclockwise direction.
8
8E
8C
8G
8 SPOUT BODY ATTACHMENT
Insert Lift Rod (8A) into hole at the top of Spout (8B). Place Plastic Seal Ring (8C)
against the bottom of Spout Base (8D). With Spout (8E) facing forward, carefully install
the Lift Rod (8A) and Shank (8F) through the center hole of sink (8G).
7F
7F
7E
7D
7A
7B
7C
8A
8B
8D
8F
ENGLISH
9
9 SECURING SPOUT BODY
From underneath sink, secure Spout Body (9A) by placing Square Washer (9B) onto
Spout Shank (9C) and tighten with Mounting Nut (9D).
Caution: Do not over tighten!
10
10K
10J
10F
10G
10A
10F

10 HOSE CONNECTION

From underneath sink, insert the Center Connector (10A) onto Spout Shank (10B), push
the Center Connector (10A) up until the top of Socket (10C) reaches the Spout Shank
Stop (10D). Be careful not to damage the O-Ring Seals (10E). Place Clip (10F) into
Spout Shank (10B) to secure Center Connector (10A).
Slide the End Connectors (10G) with arrow (10H) pointing up onto the Valve Bodies
(10J). Push the End Connectors (10G) all the way up until completely seated. Be careful
not to damage O-Rings (10K).
3
9A
9C
9B
9D
10B
10D
10E
10C
10A
10H
10H
10B
10G
10K
10J
10G