GiBiDi DCF180 Instrucciones Para Las Instalaciones página 6

6
UK
INSTALLATION
Make the connections as shown in Fig. 1 (RX) and Fig. 2 (TX). Secure and power the photocell
(12 - 24 V DC/AC.
The photocell is set up to operate in synchronised mode. In this mode, the photocells will only
work if powered with alternating current. When making the connections, pay attention to the exact
position of the cables A and B (Fig. 3).
Cover the photocell with the front panel and secure it with the screws provided. Interrupt the photocell
beam several times to check proper relay response.
JUMPER FUNCTIONS:
J3 (RX)
CLOSED = Standard operation
OPEN = Delayed operation, to be used in particular weather conditions (snow).
N.B.: Delayed operation must not be set with the synchronism.
J5 = A B: N.C. output contact
J5 = B C: N.O. output contact
CE Declaration of conformity
The manufacturer:
Declares that the products: DCF180
Are in conformity with the following CEE Directives:
• EMC Directive 2004/108/CE and subsequent amendments
and that the following standards have been applied:
• EN61000-6-2, EN61000-6-3, EN60335-1
Date 03/04/17
GI.BI.DI. S.r.l.
Via Abetone Brennero, 177/B,
46025 Poggio Rusco (MN) ITALY
The legal Representative
Michele Prandi
DCF