Idiomas disponibles
Idiomas disponibles
STEP 2: Outside Lock Handle Assembly
8000/8100/8200 DOORS, (SEE FIG. 4): Align the outside handle
assembly with the handle pointing towards the floor and insert the
assembly through the previously drilled 3/4" diameter holes in the
section. Secure the outside lock handle to the section with (2) #10
phillips head screws.
5120/5145/6100/8300/8500/9700/9800/9100/9405/9600 & WOOD
DOORS, (SEE FIG. 5A & FIG. 5B): Align the outside handle assembly
with the handle pointing towards the floor and insert the assembly
through the previously drilled 3/4" diameter holes in the section. With
the outside lock placed in the section, place the center lock stile over
the shank of the outside lock handle, secure the center lock stile with
foam tape (8300/8500/8700/9800/9700 & WOOD DOORS will use the
lock backup plate with no foam tape). Secure the outside lock handle
to the section by placing the (2) #10 phillips head machine screws
through the lock stile into the lock section.
NOTE: Before proceeding to the next step its recommended that the
outside handle be locked.
Step 3: Inside Handle Assembly
8000/8100/8200 DOORS, (SEE FIG. 6): Position the inside handle
over the shank of the outside handle, flush against the center stile.
Align the holes in the handle with the pre-punched holes in the center
stile, then turn the handle clockwise to secure with (2) #8 screws.
5120/5145/6100/8300/8500/9700/9800/9100/9405/9600 & WOOD
DOORS, (SEE FIG. 7): Position the inside handle over the shank of the
outside handle, flush against the lock backup plate. Align the holes in
the handle with the pre-punched holes in the lock backup plate, then
turn the handle clockwise to secure with (2) #8 screws.
NOTE: When securing the inside handle bracket, be sure not to over
tighten the screws or damage to the inside handle may occur.
NOTE: Follow the Main Installation Instruction Manual to install the
door sections and vertical track before you install the remainder of
the lock parts. After the sections and track are installed, continue with
STEP 4.
NOTE: On doors less than 2" thick, the shank will protrude past the
inside handle. If desired, cut the excess shank length off, flush with
the outermost surface of the inside handle. Remove burrs.
Lock
stile
Shank
Pre-punched
holes
Inside
handle
(2) #8
Screws
FIG. 7
3
3/4" dia.
holes
Outside
handle
FIG. 4
Outside
handle
3/4" Dia.
holes
FIG. 5
Inside
handle
Center stile
FIG. 6
Cut
Shank
point
Handle
Inside
handle
#10 Phillips
head screws
Shank
Universal
lock stile
Foam tape
#10
Phillips
head
Handle
screws
shank
Foam tape
Pre-punched
holes
Inside
handle
Shank
(2) #8
Screws
Backup
plate
Shank
Inside
handle
Pre-punched
(2) #8
holes
Screws
