What If There Are Problems - Beurer EM 25 Manual De Usuario

Voltage 2 x 1.5 V AAA battery
supply
Treatment 20 minutes, the device then switches off
time automatically
Intensity Adjustable from 0 to 15
Operating 10°C – 40°C (50°F – 104°F) at a relative
conditions humidity of 30 – 85%
Storage con- -10°C – 50°C (14°F – 122°F) with a relative
ditions humidity of 10–95%
Dimensions 429 x 125 x 21 mm
Weight 110 g (without batteries),
133 g (with batteries)
Note:
If the device is not used according to the instructions spe-
cified, perfect functionality cannot be guaranteed!
We reserve the right to make technical changes to impro-
ve and develop the product.

7. What if there are problems?

Problem Possible cause/remedy
Device will not - Press and hold down the " " button
switch on. again for 1.5 seconds.
- Check that the batteries are
inserted correctly and try to switch
on the device again.
- The batteries could be flat. Replace
the batteries and try to switch on
the device again.
Problem Possible cause/remedy
The gel film no - Replace the gel film.
longer adheres
to the skin.
The device - Press and hold down the " " button
beeps unusually
during use.
- There is insufficient skin contact
- The batteries could be low and
You are unable - Press and hold down the " " button
to feel any stimu-
lation. - Ensure that the gel film does not
- Gradually increase the intensity
The skin at the - Stop treating this area immediately.
area of treatment
is red.
The intensity - Replace the batteries and try again.
suddenly begins
to weaken.
17
for 1.5 seconds to switch off the
device. Then press and hold down
the " " button for 1.5 seconds to
switch on the device again.
with the gel pads. Replace the gel
pads.
must be replaced.
again for 1.5 seconds.
protrude from the device and try
again.
level.
Wait until the skin has returned to
its normal colour. Please consult
a dermatologist if skin irritation
persists.