Cooper Lighting Solutions Portfolio LDA2B Instrucciones De Instalación página 4

Installation Instructions – LDA2B/LDSQAB/LDA2BCP/LDSQABCP Commercial Recessed Adjustable LED
OPTICS
1. To remove optic, twist gently counter-clockwise. To
replace, push optic and twist gently clockwise until it
"clicks" (see figure 6).
2. Also available, is a single/double media holder. To install,
place the media onto the media holder. Engage snaps
at bottom of snap staircase. Twist clockwise until tight
(see figure 7).
Twist counter-clockwise
REMOVAL
Figure 6
Snap and twist
clockwise
Figure 7
4
COOPER LIGHTING SOLUTIONS IB520064ML
Push up and twist clockwise
to tighten
INSTALLATION
Media holder
Installation instructions
AIMING
1. This fixture allows for 365-degree rotational "aim" .
Due to the small opening, it is recommended you
remove the optic to perform this operation.
2. Insert Philips screwdriver into aiming bracket
(see figure 8a).
3. Rotate to the appropriate location. The mechanism will
remain in place once the location is found. No additional
braking or locking is required.
4. Replace optic upon completion.
5. The Square fixtures have an additional rotation feature
built into the housing in the event the installation is not
square to the room walls. Loosen two nuts from inside
the housing. Rotate the mechanism such that the collar
walls are lined up with the room walls or ceiling tiles.
Tighten nuts (see figure 8b).
Aiming bracket
Figure 8a
Loosen nuts
and rotate plate
Figure 8b
Loosen nuts
and rotate plate