Aplicaciones technologicas 520 Serie Manual Del Usuario página 10

Connect the power cables directly to the battery or to a good connection nearby.
Protect the installation with a 15 A fuse located as close as possible to the battery connection
in accordance with the wiring diagrams which appear at the end of this manual.
The lights for cars tend to be installed and to operate in pairs. We shall call the first
and the second pair of lights as "GROUP 1" and "GROUP 2".
2.5) OPERATING INSTRUCTIONS
4 strobe lights
When
switches to select the function modes: Group 1, Group 2 and Quadruple/Double and a high/
low intensity switch in order to carry out the following functions:
GROUP 1
- : Activates the lights corresponding to GROUP 1.
GROUP 2
- : Activates the lights corresponding to GROUP 2.
- QUADRUPLE/DOUBLE
lights. With the switch open (OFF) the frequency is 69 + 69 QUADRUPLE flashes per
minute (right + left), and with the switch closed (ON) the frequency is 66 + 66 DOUBLE
flashes per minute (right + left).
HIGH/LOW INTENSITY
-
high intensity (OFF) or low intensity (ON).
2 strobe lights
If only
where the pair of lights connected are those corresponding to GROUP 1. The two strobe
lights could have been indiscriminately connected to the outputs corresponding to the GROUP
2 pair of lights. In this case the user can use the QUADRUPLE/DOUBLE and the HIGH/
LOW INTENSITY switches.
Finally with just
the light has been connected to the output J6, it also being possible to connect it to any of the
other 3 outputs for lights on the power supply unit (J3, J4 and J5). The user can use the
QUADRUPLE/DOUBLE and the HIGH/LOW INTENSITY functions.
are connected (see wiring diagram on page 12), the user has 3
: This switch is used to select the kind of flashing for the
:This switch is used to select the modes of operation in
are connected, follow the diagram which appears on page 13,
1 strobe light
, follow the diagram which appears on page 14, where
1 0